Root Guard on Designated Ports

Bundle lab · $29.99

Advanced Rapid-PVST+ and Root Guard implementation on a three-switch triangle with a real loop. SW1 is the intentional root for VLAN 90 and protects its designated ports with Root Guard to prevent root re-parenting. Two Alpine hosts on VLAN 90 verify end-to-end forwarding remains stable even if a superior BPDU appears downstream.

Learning objectives

• Configure Rapid-PVST+ across all switches for VLAN 90
• Deterministically elect SW1 as the STP root for VLAN 90 using bridge priority 4096
• Enable Root Guard on SW1’s designated trunk ports toward SW2 and SW3
• Apply PortFast and BPDU Guard on host-facing access ports only
• Harden trunks with native VLAN 999, nonegotiate, and a restricted allow-list
• Verify STP state, root election, and Root Guard status using key show commands
• Confirm host-to-host reachability on VLAN 90 remains stable

Troubleshooting focus

• If SW1 is not root for VLAN 90, compare bridge priorities and MAC addresses with show spanning-tree vlan 90 on all switches.
• If a port shows root-inconsistent, check for superior BPDUs from the neighbor and verify the intended root’s priority is lowest.
• If hosts cannot ping, confirm both access ports are in VLAN 90 and trunks allow VLAN 90 end-to-end.
• If a trunk is up but no user traffic passes, verify native VLAN alignment and the allow-list includes VLAN 90 on both ends.
• If an access port err-disables due to BPDU Guard, identify the source of BPDUs (loop or unauthorized switch) before re-enabling.